Dark Energy Creations

Tilting mount adaptor for standard stenography machines.

Order Link At Bottom Of Page

- Solid aluminum and brass construction.
- Adjusts up to 30 degrees forward and backward.
- Easy lock/unlock handle.
- Reduces stress on the shoulders, elbows, and wrists.
- Quick adjust to prevent pain from extended use at the same position.
- Adapts to tripods with standard mount (see below).
- Fits standard mount tab measuring
- .28 inches (7.1 mm) wide
- 1.0 inches (25.4 mm) long
- .51 inches (12.9 mm) diameter center
- Mounting screws and wrench included.
- 30 day money back guarantee *.
- One year limited warranty **.
- Made in the U.S.A. with U.S.A. materials.
- ( TRIPOD NOT INCLUDED )
- Modifying your tripod may be required, please see below.

Adjusts up to 30 degrees forward and backward.

Instructions:
- Screw tilting adaptor to the tripod with the two included screws.
- Make sure that the washers on the screws are in the same order they were taken off.

- This item is made to fit standard stenography tripods with holes in the flange as shown.
If your tripod does not have these holes you will have to drill them in.

- The split lock washer goes on the screw first, then the flat washer goes on the screw.
- Then put the screw through the hole in the tripod and fasten the tilting adaptor to the tripod.

Stenography